Posted by farmallFlan on January 30, 2010 at 17:09:06 from (69.77.242.75):
This is just an account of my day today. I know there is other good info regarding putting new cables on a F10 farnhand loader. I bought 60' of 3/8" cable and four clamps. When you hook the cable to the end of the cylinder that tips the scoop make sure to make dry runs with both ends of cable to each side of the bucket to make sure they'll reach. I left the bucket on and put a barrel under the lip and lowered the loader so the bucket was all the way back. Then I made sure that the bucket cylinder was in the position as if it had the bucket pulled all the way back.
Once the cable was hooked to the end of the cylinder I put the cylinder back in, hooked the cables to the bucket and tested her out. I had to take up some slack on each side at the bucket and it was good to go.
I was all worried about how the cable ran thru the pulleys but I took a picture of the two pulleys on the upper left side(on most F10's) and it was easy. Hope this helps someone.
Thanks to Allan(Ne) for his 2005 or 2006 post regarding cables.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - History of the Field Marshall Tractor - by Anthony West. Any restorer who has some knowledge of turn of the century farm machinery, will recognize the name Lanz Bulldog!! This machine was to say the least unusual in its appearance. The huge flywheel and coffee percolator shaped exhaust. Along with square body lines and cylinder head protruding forward of the front axle. Would become the visual differentiation that people would quote to separate the Lanz from other period machines. The Marshall company based at the Briannia Works in Gainsborough
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
