Posted by CLTX on January 23, 2010 at 18:44:02 from (70.140.69.93):
In Reply to: OT/Old Barn posted by Burn or Salvage? on January 23, 2010 at 17:27:03:
Those could be worth quite a bit to the right people, due to their length and depending on their variety. A friend of mine had an opportunity to tear down an old house and keep the lumber. The house had been built in Galveston shortly after the 1900 hurricane. The ceiling joists were fir, full 2 x 12's (2 1/8 x 12 1/4). I think that they were either 20' or 24' in length. He had them ripped into 2 x 8's. I helped him move the resulting 2 x 4 leftovers. When I reached down to pick one up, I thought I had gotten hold of a tree. Those things were HEAVY. I tried to drive a nail in one and the nail bent, every time. A person would have had to drill a pilot hole. You very rarely, if ever, see lumber like that any more for framing.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
