...uh, don't do much with guns anymore (I hate cold weather and prefer to fish off of my boat in warm weather). However, 30 years ago I worked in a gun store and owned a .270 rifle. Mixing calibers in any gun, especially high-powered rifles, would be in my humble opinion both very stupid and very dangerous. A bullet has to fit snug to the bore of the barrel as it spins during the travel out of the gun. It is the seal of this fit that forms the barrier for the compression of the powder fire. If memory serves I used to shoot 110 and 130 grain loads from my .270 and fire would shoot out of the end of the barrel five or six inches when using the 130. It was pretty hot - I bought the .270 as a "hot-rod" kid because the kill power was slightly better than a 30-06 and it was a popular caliber with bear hunters in the 70s. I thought it was "cool" at the time, but I could barely afford to shoot the stupid thing and I never went bear hunting with it or any other gun. I had enough bad luck shooting a cousin's shotgun reloads on trap (an he was a pretty good reloader) that I don't think I would consider shooting an amature reloaded anything in a .270, 30-06, .357, etc, etc. (anything with a bore and some power).
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Revival of a John Deere Combine - by The Red, John Fritz. For several years I had been driving by a farm house on the west side of Indianapolis that had a John Deere combine parked in high weeds in a lot behind the house. The gentleman no longer farmed because the entire area was developed with housing and light industry. I had stopped several times and knocked on the door but no one would answer. My curiosity was up and I wanted to contact the owner. I wanted to see what he planned to do with the combine.
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
