Posted by ScottyHOMEy on January 19, 2010 at 19:39:10 from (64.222.222.251):
In Reply to: What would you do?? posted by randy47 on January 19, 2010 at 17:38:34:
Where I grew up, the dog got one freebie, as long as he had not yet don't any lasting harm to the livestock. If he had an animal down, he was shot.
If the dog was spared on the first encounter, his owner was put on notice, and the rule after that was zero tolerance.
Been on both ends of that deal. The very few dogs we ever had get in trouble never ran loose again (several solutions to that, all humane). Those that returned to our place didn't leave after our best attempt at a humane shot. No regrets in either case. That's how it works.
The rules for strays/wanderers harassing pets vary a lot, but most places allow for defense of persons and livestock.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.