Posted by James22 on January 16, 2010 at 21:24:06 from (207.179.239.58):
In Reply to: Re: planter? posted by JMS/.MN on January 16, 2010 at 10:03:27:
Really love it when you and the others talk down the cyclos. Makes them cheaper and eventually I might be able to upgrade to a 955 from my 900 and spend few dollars. Neighbor has a new JD with the whole precision works, 20/20, air bags, RTK and auto row shutoffs. Can't tell the difference in his and my spacing and his emergence wasn't better. However I did drive around 4 mph. Also University studies show seed spacing isn't that critical within reasonable ranges. But the OEMs selling the equipment and others the special parts have sure got the farmers buffaloed. No doubt that a calibrated finger planter will have better spacing than a cyclo, it just doesn't give more bushels.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
