Put the frt loader back on my tractor, go over, replace the blade, and learn how my sicle mower works or remove it all together and get a drum/disc mower. finish some straightening up, empty and start over on my workshop (I's gots messy syndrom), go through piles of junk stashed everywhere and haul to the dump anything that I haven't seen in 2 or more years unless it's a tool or obviously something I need. Put siding on the barn, and run, heat, and insulate new water lines/drinkers in the stalls, and run some new lights. How much will I get done??? I'm hopeful of all but realistic enough to go for half.
Did have a Russian guy looking for some part time work that looked pretty promising though, and would prolly enjoy a lot of the stuff I plan on dumping.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Reflections of the Fifties - by "Country" Elliott. I remember rowing up in the 1950�s in a small, rural town in northwestern New Jersey. The closest town to ours was only 3 miles away, and there were seven dairy farms in the areas of these two country towns. We had 5 acres, and because my Dad was a salesman and not a dairy farmer, he let the Bockovens, who owned the Willow Tree Dairy farm most of our land.
... [Read Article]
Latest Ad:
1 SD Gibson, 1 D Model needs rear end assembled and installed, 1 D Model needs minor repairs, extra parts
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
