Posted by billonthefarm on January 14, 2010 at 18:05:51 from (98.108.64.166):
We are still going. When we quit tonight we have 24 acres left to help our neighbor get finished up. The temp climbed to 40 degrees today so the snow started to melt. Just hard to get used to looking out at the corn head and seeing snow.
We ran into some down corn today and our only option is too leave it. The snow will melt and maybe there will be something left to go get. It was about 5 acres.
There are certainly places that arent frozen. I only had about 300 bushell in the auger wagon when I found this spot. Was able to make it out but it was close.
A proud combine operator. He swung around to head back and the rear of the combine dropped into this water way full of snow and he was stuck. Deep snow and the tires just spinning on the frozen ground were a bad combination.
It delayed it us over an hour or so but after breaking the first chain and making a few trys the combine was freed. Hopefully before noon tomorrow we can wrap this up and head for home. The warm weather feels nice but it is making a tough job even more complicated as it gets muddy. Oh, dont worry wrigley is there every step of the way. He is napping by my chair right now, big day for him! bill
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Product Review: JB Weld - by Staff. JB Weld is basically an epoxy glue that does an exceptionally good job of bonding to cast iron and steel along with several other materials. As I mentioned, it is so common that I have yet to buy a tractor that did not have JB Weld used somewhere. It is sometimes used so well you can't tell its there and other times used as a sloppy quick fix. Finding where and how it can be used correctly is key to whether you are using it as an "inelegant hack" or an integral solution to difficult and expens
... [Read Article]
Latest Ad:
WANTED Front grille/nose assembly for Massey Ferguson 1160 (also fits 1180 & 1190). Headlight-mount section. AGCO Grille 3706022M91 (supersedes 3705942M91), cover 3705494M1/M2, holders 3705501M91/3711158M92. New/NOS/good used OK. Jonesboro, AR - will pay shipping. Photo appreciated. Thanks
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
