Posted by Dan in North Houston on January 12, 2010 at 15:23:59 from (38.100.70.66):
Growing up we were bordered by a railroad and a river, so we had no shared fences with neighbors to deal with. Now I got a place with two shared fences. One side is a scrub wood lot, some big oaks and lots of yaupon (a big evergreen shrub that gets about 12' high and just keeps spreading). This side is owned by a family trust with an address several hundred miles away. I had a couple of big oaks down over the fence that I've cleared out, and cut out a lot of the yaupon on my side. The oaks have been down for years, no evidence that anyone on that side has even looked at their property in years. Barbed wire fence is pretty old but was holding the cattle in because there was nothing attractive on that side. Other side owned by a retired cattle farmer, pasture land that has not been grazed in some years and will badly need brush hogged in a few years. Some yaupon and thorny scrub trees trying to take over the fence row, but not too bad right now. I'd sure like to take my brush hog and make a few runs down his side, would benefit both of us. This guy has a large tractor, but it doesn't look like he's done much to maintain his property recently. Haven't met him, but I suspect it may be age or health related. it may be age, health I'm clearing out my side as time allows, but what are your experiences in getting neighbors to allow access on their side? How about getting them to chip in for some new posts and barbed wire? Any luck in getting them to chip in when their large trees fall across the fence? I have no idea who originally built the fences, but I'm going to have to upgrade before I turn any cattle in. I've resigned myself to doing it all myself, but I'd appreciate any comments. Note: tractor related since there's a tractor inside this fence.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Day Mom Drove the 8N - by Brian Browning. My Dad was wanting to put in a garden but couldn't operate the 8N and handle the old horse drawn plow he had found and rigged up to use with the tractor. Well, he decided to go get Mom out of the house and have her drive the tractor while he walked behind the plow. You got to understand that while my Mom is a hard worker who will always help whenever she can... she had never operated farm machinery before that day. Dad got her out there, explained how the clutch was the same as in our o
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
