440roadrunner said: (quoted from post at 11:50:59 01/11/10)
I believe the main reasons these were introduced is because of things like electric blankets. They are SUPPOSED to sense an arcing condition. I have no idea how they do that---but as an amateur radio operator I can tell you that one of the two that were installed in my house was a constant nuisance due to RF.
I'm guessing that even something as simple as a poor switch in a table lamp could cause them to trip. All I've found with Google is words like "they contain a computer chip" or "advanced electronics." I assume they look for noise on top of a "normal" 120V sine wave.
One of several conditions that will trip them is a series of 3 to 8 half-cycle currents exceeding 50amps within 1/2 second period. There are also varying currents to neutral, to ground, etc. that will trip them. As with GFIs, all current that goes thru the hot line MUST return thru the associated neutral, not via some other neutral (no shared neutrals). They are not just for blankets. Bad wiring, loose connections, etc.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.