Tractor Talk Discussion Board |
Re: Need your input on rollover protection
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Sam (MO) on March 01, 2001 at 05:50:45 from (192.251.173.7):
In Reply to: Need your input on rollover protection posted by Ron McGee on February 28, 2001 at 15:30:06:
Ron If that steep grade really needs mowing, and if it's possible, try going straight up and down the hill. This will reduce you chances of a rollover. Of course your ground speed will need to be low, but with a rotary mower you can still have the needed RPM's to mow. Like the others have stated mowing 40 is not wise, hay it, pasture it, tons of other possiblities. I myself, have a hill that has a 7% grade on it, with a pond on the top of it. The only reason it get cut is because it keeps the wife happy when she looks out the back window. Well, that's my two cent worth, just be safe!! Sam
Follow Ups:
Home
| Forums
Today's Featured Article -
My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|