Tractor Talk Discussion Board |
Re: dumb questions
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Charlie on February 27, 2001 at 16:24:12 from (209.130.148.44):
In Reply to: dumb questions posted by double b on February 27, 2001 at 15:01:06:
I think one of the most important things is to have a plan as to what you're actually going to do and what actually needs to be done. It's pretty easy to sink a lot of money into a tractor and it gets worse when you get into a project and find it costs more than you thought (or told your wife). You also need a little time to track down any parts you will need. I hate being ready to put something together and finding the parts haven't arrived. When you finally get started you need a place where you can leave the parts and not have to move anything until the project is done. If you have to put parts into containers and move them all over the place its easy to forget where they are. Perhaps the worst problem is to have your tractor torn apart in the garage and your wife decides the car can't sit outside any longer.
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|