Tractor Talk Discussion Board |
Re: Farmall H Model (carb?)
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by dick on February 26, 2001 at 08:27:13 from (63.120.111.98):
In Reply to: Farmall H Model (carb?) posted by Chad Stegner on February 25, 2001 at 23:20:20:
You'll probably get better results asking this question over on the Farmall/IH board. I'm assuming what you're calling the exhaust hose is actually the air hose between the air cleaner and the carb. Getting gas into this location generally means either that your float valve won't shut off properly, or that you have the float level set too high. If you're not seeing gas coming out when the tractor is not running (with the gas valve open), the problem is probably the latter. Setting the float level to be lower in the bowl will quite likely fix your problem.
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|