Re: built a loader frame, now how to measure for the cylinders?

Posted by Catless on February 26, 2001 at 03:06:10 from (209.94.172.135):

In Reply to: built a loader frame, now how to measure for the cylinders? posted by dave on February 25, 2001 at 16:00:01:

Don't forget to extend the cylinder a little so it raises the front end a little in the full down position, I know it might be obvious to do that but could be easily forgotten, I would say extentd the ram about 1" to 2".

Follow Ups:

• Re: Re: built a loader frame, now how to measure for the cylinders? Scott Green 04:19:10 02/26/01 (0)

Post A Followup Name: E-Mail: Subject: Re: Re: built a loader frame, now how to measure for the cylinders? Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]