Posted by TimV on January 06, 2010 at 08:25:03 from (24.39.241.218):
In Reply to: Broken dowel pin posted by Icuby on January 06, 2010 at 05:41:17:
The fun part about a dowel pin is it is probably going to be hardened, which will make drilling, tapping, etc. considerably more difficult. You may be able to use a combination of methods--perhaps welding two nuts together, welding them to the pin, then using a slide hammer on a bolt threaded into the nuts. That way you'll get away from having to drill and/or tap it, which may require carbide or cobalt tooling. You may get lucky and the dowel will only be case-hardened, in which case another thing to try is drilling and tapping the "soft" center for a grease zerk and pumping grease into the hole, which will push out the dowel pin.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Harry Ferguson - The Man & The Machine Harry Ferguson was christened Henry George but every one called him Harry. Harry was born in a small Irish town called Growell in County Down about 16 miles from Belfast. Harry Ferguson led a varied and colorful childhood causing mischief where ever he could. He showed mechanical aptitude at a very early stage in life and showed no inclination towards
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
