Last year in the spring I saw 2 different stations on TV with 2 different programs predict this cold for this winter. I hoped they were wrong but I did cut extra wood because of this prediction. What they base the prediction on was the gulf stream that runs north and south along the east coast. What"s happened is the ice in the north has melted and that part of the ocean is 90% fresh water. The salt has been pushed south and the % of salt is much higher than normal to the south. They showed the salt and temp sensors that were used in the ocean to record over the years and showed the change in both. The gulf stream sends warm water up north at one level of elevation in the ocean and comes back at a lower level. The lower level is where the salt is being pushed back south out of salt water being replaced with fresh water.
Now I"m not one to believe glabal warming is caused by humans but I am old enough to see for myself how much the weather has changed in the last 50 years. This winter is much like we use to have back in the 50"s 60"s and early 70"s. I think it"s a natural event but none the less it"s a change. Just glad I have the extra wood to make it through this winter. I already know of folks that are running out of seasoned wood now. Have seen the price jump $30 a pickup load.
From what was predicted last spring and what I see now I plan to have even more wood ready for next winter. This may be a new winter trend. I see oil has already gone to $80 a barrel. I"m sure the cold weather across the country has speculators running that up right now.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
