Had a neighbor in late 70s with front duals on a Deutz! He"d try anything. This one is inadvertantly turned up- pump sent fuel into the crankcase, had a rebuild put on, wanted it turned up 10% like usual. Jobber already sent it out, mechanic said it dyno"s 190, and if we really push it we can hit 240. 4450 is rated 145. Says just run the same load at the same speed and it"s ok. With the 15 speed, I can cruise along and in a tough spot, always pop it up 2 gears to make it through. I don"t run the front duals continuously- just in real wet Fall seasons, to get tillage done. This will be the puller for my tile plow when I get that built. I"ve seen the ice spurt out in peat ground some years, but it carries it through. Does put a bit of strain on the front when turning, even with the smaller size- steering is affected at low rpm.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.