Posted by paul on January 01, 2010 at 22:44:41 from (66.44.132.155):
In Reply to: Re: tire ballest again posted by Wilamayb on December 31, 2009 at 18:15:27:
I have liquid in 3 of my tractors. Ford 7700 (all 4 tires), Ford 980, and NH 1720.
I wouldn't run those tractors, or be able to farm as well as I do, without the fluid.
To each their own, but I can't imagine finding wheel weights for that Ford 7700. I couldn't use the 3pt as well, nor pull 600bu of grain, nor round bale the road ditches, without the weight on all 4 corners. Stacking that much weight on the wheels would stick out, make it less manuverable for me.
To each their own, if iron works for you then by all means, but it sure doesn't fit my needs. My IHC H loader tractor has 400lbs of concrete bolted in the rear wheels, and another 300lbs when needed on a platform on the rear hitch, so I understand using solid weights in the right place as well. Not a bad solution if it meets the needs.
I'm considering what to do with the Ford 5200 I got, traction is sure an issue with it, but for planting I hate to make it too heavy. It's got a bunch of 1/4 rear wheel weights underslung on the front axle, which are in my way for spraying rowcrops the 2nd time - hurt the corn or beans. But - I don't know how well it will pick up round bales if I remove that. So - thinking over my options.
When I want weight, I want weight. Antifreeze or windshiled washer fluid doesn't cut it, need to use the salt or sugar. Some of us actually use our tractors, and need them balanced properly. Can't use off-the-wall hack solutions that don't actually add weight.
I know this topic is a pet peeve of mine on this forum, so again - to each their own, if these things work for you that's great - I just don't get it myself. Wrong tool for the job imho.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
