|
Tractor Talk Discussion Board |
Pacer steering knuckle mounting boss snapped off
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bob LaBrie on February 21, 2001 at 05:54:50 from (32.101.171.234):
I need a Pacer owner to take a peek at the front
end and please tell me how much room I have for reinforing the mounting boss for the front steering
knuckle. I have some detailed photos of what I
am talking about and I need to know how much clearance there will be for reinforcing this
area. I acquired the tractor disassembled and have not secured manuls as of yet so I'm not sure how much room is down there. The front section of the tractor is removed and I am working to remove the frozen piece of the front section from the steering knuckle. I realise there is no room for reinforcing on the bottom because the steering knuckle needs the clearence to swing, however the topside of the front section where the mounting boss protrudes upwards I belive there is room to reinforce...just not sure how much.
If you choose, look at photos 17, 18, 19
thanks, Bob
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
The Revival of a John Deere Combine - by The Red, John Fritz. For several years I had been driving by a farm house on the west side of Indianapolis that had a John Deere combine parked in high weeds in a lot behind the house. The gentleman no longer farmed because the entire area was developed with housing and light industry. I had stopped several times and knocked on the door but no one would answer. My curiosity was up and I wanted to contact the owner. I wanted to see what he planned to do with the combine.
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
