Re: Home built Log Skidder,

Posted by Tom R on February 18, 2001 at 13:02:25 from (207.91.28.31):

In Reply to: Home built Log Skidder, posted by Canadian Cowboy on February 17, 2001 at 19:23:26:

About 20 years ago I had a similar Idea to build an articulated skid steer loader. I had started to gather up the materials, I was going to use the rear end's and frames from 2 old Allis Chalmers WC and use a 350 Chevy to drive a hydraulic pump. The plan was to use a hydraulic motor on each of the rear ends to drive the input shafts (no transmissions) and then use a single pivot pin to connect the two frames so hydraulic cylinders could provide the articulation. Before I had found a suitable pump circumstance changed and I no longer had need for it so it did not get built but I think hydraulics is the way to go.

Tom R

Follow Ups:

• Re: Re: Home built Log Skidder, Canadian Cowboy 16:26:39 02/18/01 (1)
  • Re: Re: Re: Home built Log Skidder, Tom R 04:11:58 02/19/01 (0)

Post A Followup Name: E-Mail: Subject: Re: Re: Home built Log Skidder, Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]