|
Tractor Talk Discussion Board |
Re: 1952 ford 8n front end spindle bushing radius rod pin
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Al English on February 18, 2001 at 09:56:50 from (24.30.29.47):
In Reply to: 1952 ford 8n front end spindle bushing radius rod pin posted by m.kennamer on February 18, 2001 at 09:31:35:
A bearing supplier would have access to the bushings you want. If you're really handy with a die grinder you could put them in yourself. Grease distribution grooves will have a lot less to do with the life of your bushings than will frequent greasing. And, the grooves reduce the area of the bearing. There are arguements on both sides of this issue, so if you want grooves, don't let me change your mind. Good luck...Al English
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Tractor Implements and Their Use - by Curtis Von Fange. Dad was raised during the depression years of the thirties. As a kid he worked part time on a farm in Kansas doing many of the manual chores. Some of the more successful farmers of that day had a new time saving device called a tractor. It increased the farm productivity and, in general, made life easier because more work could be done with this 'mechanical beast'. My dad dreamed that some day he would have his own tractor with every implement he could get. When he reached his early sixties
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
