Posted by RN on December 26, 2009 at 11:16:41 from (96.60.79.133):
In Reply to: O/T Rifle Question posted by JBMac76 on December 26, 2009 at 05:47:32:
Clean barrel good, then clean again. bore snakes seem to help for some people. Lead slug or buckshot pushed down barrel will give a measurable rifling impression and tell if bore is worn beyond specs. If crown is worn and don't want to rebarrel- see if gunsmith can do a recessed recrown job. This means you end up with 1/2 inch to inch or so of smoothbore at end of barrel and crown recessed. Crown rubs known to happen when cleaning rod is used from muzzle end without bore sleeve/cleaning cap- unfortunately the lever actions are the main ones to get this type of cleaning and have the egg shaped, nicked crowns. Reccessed crown sometimes on target rifles or black powder rifles, cleaning rods have a plastic sleeve that fits in smoothbore end and acts as cleaning cap instead of using a false muzzle like the old Pope target rifles. RN
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A Belt Pulley? Really Doing Something? - by Chris Pratt. Belt Pulleys! Most of us conjure up a picture of a massive thresher with a wide belt lazily arching to a tractor 35 feet away throwing a cloud of dust, straw and grain, and while nostalgic, not too practical a method of using our tractors. While this may have been the bread and butter of the belt work in the past (since this is what made the money on many farms), the smaller tasks may have been and still can be its real claim to fame. The thresher would bring in the harvest (and income) once a y
... [Read Article]
Latest Ad:
1 SD Gibson, 1 D Model needs rear end assembled and installed, 1 D Model needs minor repairs, extra parts
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
