Posted by Mel in SW Iowa on December 26, 2009 at 06:49:05 from (75.104.160.37):
In Reply to: O/T Rifle Question posted by JBMac76 on December 26, 2009 at 05:47:32:
Have an experienced gunsmith or armorer examine your rifle if possible. If the muzzle rifling or crown are damaged, they may be able to cut and recrown your barrel for a reasonable cost.
I would look for a good SKS 7.62 x 39 for a feral pig gun. I have sighted in several for people over the last 30 years and haven't shot one yet that wasn't a good shooter. The only modification that I like to make on them is to cut the rear sight groove with a round chain saw file. File it half way down into the rear leaf to give yourself an open top peep sight. It provides the best open sight imaginable for moving targets. It naturally draws your front sight to the center of the circle, but the open top doesn't cover up your target.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Memories of an IH Super A When I was ? up to 10, I worked on my Papaw's farm in Greeneville, TN every summer. As I grew older (7), it was the thrill of my day to ride or drive on the tractor. My Papaw had a 1954 IH Super A that he bought to replace a Cub. My Papaw raised "baccer" (tobacco) and corn with the Super A, but the fondest memory was of the sawmill. He owned a small sawmill for sawing "baccer" sticks. The Super A was the powerplant. When I was old enough (7 or 8), I would get up early and be dressed to
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.