Posted by Chris in ND on December 21, 2009 at 18:34:40 from (75.61.96.254):
In Reply to: OT/ for the gun guys posted by Ricey06 on December 21, 2009 at 13:50:07:
I would let the pump Remington go, espically if you are happy with your 35 Rem. Your Marlin is more than adaquate for deer (and moose for that matter) up to 200 yards. Ammo avalibility is the only advantage the 308 has for the way you hunt. However if you ever end up out here hunting Mule Deer or Pronghorns, a pump carbine is not the best choice, but it will work, quite well actually, but most guys like bolt guns and longer barrels. I once owned a 7600 in 270. Its trigger was like pulling a toilet plunger through a bucket of rocks. I also have a 760, an older version of that rifle, in 300 Savage. No trigger problems. It shoots sub 1 inch groups with 130 grain Speers. I use it for Coyotes. What amazes me, is that good bows now cost more than really good bolt rifles, like Savage/Stevens line, the Marlin MR 7and even the Weatherby.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Engine Valves - Some Helpful Information - by Staff. Intake - On the intake stroke the piston moves doward, sucking in carburized fuel through the open intake valve. Exhaust valve is closed. Compression - With both the intake and exhaust valves closed, the pistons upward stroke compresses or squeezes the fuel into the combustion chamber. Firing - Ignited by the spark, the compressed fuel explodes and forces the piston downward on its power stroke. Intake and exhaust valves are closed. Exhaust valves and seats are exp
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.