Posted by John A. on December 20, 2009 at 19:04:23 from (76.1.122.170):
In Reply to: Re: stuck posted by Mike (WA) on December 20, 2009 at 14:52:28:
Mike, I must question your defination of violence! When one breaks out the 4x4 block, a 5 lb sledge hammer and cheisel and the piston starts comming out in pieces is the violent approach IMO. I an taking about simple disassembly of an engine, and overcoming the stuck pistons with heat/fire. I have seen engines that have been stuck for yrs taken completely apart in an afternoon with this method and the pistons were reusable after it was done. Depending on the amount of water that was in the engine and how long and often it sat in water. Simply Rering the pistons and Hoan the liners if they weren't rust pitted, would have worked on a few but it is still better to know than to guess on the internal condition of the engine. My premise is there is usually a reason the tractor was parked to begin with and the engine later stuck and the tractor finally was abandoned is some fence row. So the engine needs to come apart and be looked at! Later, John A.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Machine Shops - by Curtis Von Fange. It is a story that repeats itself countless times. In the process of rebuilding a particular section of the tractor there is a broken part for which a replacement cannot be found. The parts houses find in their catalogue that it is unavailable. The dealerships call it a discontinued part. Salvage yards define it as hard to find or, even worse, rare. Everyone on the NET says, 'what is it?' But don�t despair there is another avenue that can be used to get that piece repaired. The local mach
... [Read Article]
Latest Ad:
1 SD Gibson, 1 D Model needs rear end assembled and installed, 1 D Model needs minor repairs, extra parts
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
