|
Tractor Talk Discussion Board |
Re: D17 Generator conversion
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by bored stiff on February 09, 2001 at 23:58:43 from (208.235.23.17):
In Reply to: D17 Generator conversion posted by george on February 09, 2001 at 16:45:21:
Well I don't think you'll get lucky enough to use the original bracket without some mods.As I remember the front motor mount really gets in the way with the D-17. I used a GM 10SI one-wire alt. with the extended pivot front housing to get up and over that motor mount. The wiring is simple,run wire from output terminal of alt. into the wire that comes off the BAT terminal of orig. voltage regulator swap leads on back of the AMP meter and swap leads on the distributor and ground NEG post of battery. The starter won't know the difference. Hope that helps.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Tractor Implements and Their Use - by Curtis Von Fange. Dad was raised during the depression years of the thirties. As a kid he worked part time on a farm in Kansas doing many of the manual chores. Some of the more successful farmers of that day had a new time saving device called a tractor. It increased the farm productivity and, in general, made life easier because more work could be done with this 'mechanical beast'. My dad dreamed that some day he would have his own tractor with every implement he could get. When he reached his early sixties
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
