While you had it worse than most in your area, the growing degree days were too short this year in most of the midwest & corn everywhere was very wet. One load of mine tested 36&; a lot were between 28-30%, now at the end some got down to 19% but very few; 23-24% was normal even at the end. We planted ahead of normal & had a very dry summer.
We had a different type of mold grow on the corn kernals. They say ours wasn't harmful, but wow it's scary to see that. Never really saw anything like it before.
The mold you have is a regional thing, it affected your area real bad. It makes animals sick; they actually refuse to eat the feed if the levels are too high. Either your corn will need to be hauled out; or non-moldy corn will need to be hauled in. Then get blened together to get the bad mold level low enough.
There is still regular hybred corn available, but it is a bit harder to find. Much seed is controled by 3-4 companies, one for sure is trying to get everything as a triple-stack or more. But there are other sources, you can find regular corn seed if you look.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.