John Morrissey said: (quoted from post at 19:19:07 12/13/09)
There are two wires running to each of the lights, a power and a ground (I am assuming the black wire is the ground wire as it goes to all the lights). The power and ground wires originate at the switch. However, I have no continuity between the ground wire and the frame. If I run a jumper from ground to this this ground I have power to the lights.
So, I think I lost my connection from this ground wire to the frame. Does anybody know where this ground originates?
Buickanddeere, can I get a good wiring diagram at the # listed, the one I have is pretty fuzzy with not a lot of detail.
The 800 phone # is JD's phone # to order manuals in which the tech manual will have a wiring diagram. A wiring diagram for a 4020 which will be close is on this site in the archives under a mans handle named Gwece
Finally no ground wire on factory wiring was on light switch. Ground only went through frame by way of the grounding wire on rear post to frame on LH battery
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
