Tractor Talk Discussion Board |
Re: Anyone ever use a hydraulic top link?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Robert on February 07, 2001 at 14:40:19 from (204.157.28.114):
In Reply to: Anyone ever use a hydraulic top link? posted by Shep on February 06, 2001 at 20:58:09:
I've built two of them over the years. I made the first one with a 2" cyclinder, and it wasn't long before the cyclinder was damaged, and leaking with a some what bent shaft. I made the second one out of a 3" cyclinder. It's about min. size to use. I bought a 3 point ball end, and adapted it to go between the tractor and the cyclinder. I was useing this all the time, the first year or so, but now i find my self going back to regular top links. It was really use full when i used it with a set of 3 point pallet forks i all so made. If you go to a farm store and buy several weld on ball ends, it's really easy to measure some pipe, or flat bar for the length of your implement, and weld up several sizes you need. Robert
Follow Ups:
Home
| Forums
Today's Featured Article -
Restoration Story: 1951 Farmall H - by The Red (John Fritz). I have been a collector of Farmall tractors since 1990 when I first obtained part of the family farm in Eastern Indiana. My current collection includes a 1938 F20, 1945 H, 1946 H, and the recently purchased 1951 H. This article will focus on what I encountered and what I did to bring the 1951 NEAR DEATH Farmall H back to life.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|