This article is provided as a public service by the Geophysical Institute, University of Alaska Fairbanks, in cooperation with the UAF research community. Larry Gedney is a seismologist at the Institute.
It is well known that the wind-chill factor can lower the effective temperature experienced by human beings by many degrees, depending on the velocity of the wind. The debatable question often arises, "Does it also affect machines?"
Many of us have had the experience of sitting in a car at a stoplight with clear windows, only to have them fog up again when the car starts moving. More often than not, this is a result of snow that was on the hood being sucked through the car's heater system; but there is another factor involved as well, and that is wind chill.
If we were to take an engine block and install it on mounts in the middle of a field for the winter, it would make no difference in the temperature of that engine block if the wind blew or not. It would remain at the ambient temperature of the air surrounding it, whether or not the air was moving. However, if we were to start up that engine and let it warm up, there would be a great deal of difference in the block temperature depending on whether or not the wind was blowing.
Any object that creates its own internal heat will find that heat is removed from it faster if the air around it is moving. It is simply a matter of heat transfer--the "conveyor belt" of moving air (convection) will snatch the heat away much faster than if it were still.
So the answer to the question is yes. Wind chill does affect machines, but only if they are at a temperature above that of the surrounding air.
You were doing really, really, really good until you said "wind chill", then it went in the crapper. Sorry. I wish you had just said "wind" or "wind velocity". Once you interject the "chill" word, you transitioned into the human perception of cold.... an immeasurable perception of the human mind, which there has been an attempt only to quantify by sampling the feelings of a group (sample) of humans. Yes, there is a formula, but it as not derived scientifically, but by testing the 'feelings' of a number of sample subjects.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Field Modifications (Sins of the Farmer) - by Staff. Picture a new Chevrolet driving down the street without it's grill, right fender and trunk lid. Imagine a crude hole made in the hood to accommodate a new taller air cleaner, the fender wells cut away to make way for larger tires, and half of a sliding glass door used to replace the windshield. Top that off with an old set of '36 Ford headlight shells bolted to the hood. Pretty unlikely for a car... but for a tractor, this is pretty normal. It seems that more often than not they a
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
