Posted by Fixerupper on December 09, 2009 at 06:57:10 from (207.177.13.178):
In Reply to: TRUING a FEEDER Augar posted by J Heitkemper on December 09, 2009 at 06:18:30:
Leland is right. A bent auger should go to the junk pile. It can be straightened but someday it'll give up the ghost. We have half-straightened an auger in a pinch by cutting out a small section of the tube in the right spot and heating it in another spot to get it half way usable, then welding the patch back in to the spot we cut away. About a hundred hours later the auger will crack most of the way around and then there's not choice but to replace. I'm pretty sure an auger from a 1010 head will work but make sure you look at serial numbers cause there are differences between the newer and older heads.Good luck. Jim
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Search For Spares - by Anthony West (UK). Following on from the aquisition of the old Fordson F, I was very much in need of spares. As a novice though I didn't appreciate the fact that there were so many Fordson tractors made, that all the other makes seem rare by comparison. As far as I was aware a fordson was a fordson and it was only through trial an
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
