Tractor Talk Discussion Board |
Re: John Deere 730 PTO
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Fudd@Work on February 05, 2001 at 19:57:50 from (205.242.73.10):
In Reply to: John Deere 730 PTO posted by 30series_man on February 04, 2001 at 18:14:05:
It probably just needs a shaft seal. If you are real experienced at it you can remove the old seal and replace it with a new one without removing anything, I think. If it is posible you can drill a small hole in the metal part of the seal and screw a sheetmetal screw in it and pull the seal out. Be carefull not to tip the new seal lip when putting it on the shaft and tap it in with a hammer. Don't do this unless you are comfortable with it or experienced. Good luck.
Follow Ups:
Home
| Forums
Today's Featured Article -
Talk of the Town: The Saga of Grandpa's Tractor - by The following saga is from the Tractor Talk Discussion Forum. Someone. The saga starts with the following message: Hey guys I have a decision to make. I know what you all will probably suggest and it will probably agree with me way down inside, but here it is. I have a picture blown up and framed in my "tractor room" of a Farmall M. It was my Grandpa's tractor, of which whom I never got to meet. He froze to death getting this tractor out of the barn to pull a truck out of the ditch before I was born. Anyway my dad and aunt had to sell it at the auction,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|