Posted by Gerald J. on December 08, 2009 at 08:15:33 from (70.219.156.183):
In Reply to: Planter Questions posted by Erik Ks Farmer on December 07, 2009 at 18:37:56:
My crops were much better with the 7000 than the 400. I paid $1500 for a 4 row wide, then spent bucks on narrowing the wheel frame, rebuilding the finger units, and adding Kinze bean units plus Dawn trash whippers. I'll put it up against any new planter for planting quality. This year I rented out the land so I could do other things so I should be working on selling my planter. I'll do that in a year or two. Want to keep it to keep pressure on the tenant.
The 7000 planter is very nearly as good as the latest planters but you have to check it for wear. The main wear spots are the gauge wheel arms and the tail piece bushings. The gauge wheels should be tight against the opener disks and without side shake. Opener disks wear too. The tail piece should only move up and down, not side to side. All these bits are replaceable or repairable, both from deere and from after market makers, like Shoup and RK products.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
