Posted by Old Roy on November 27, 2009 at 12:29:02 from (98.17.222.64):
In Reply to: Back on the farm :-) posted by Lanse on November 26, 2009 at 19:06:26:
Lance ,
One thing to look for on that mag is for the shutdown wire may be pinched and shorted out.
But do first he recommended setting of the points.
Make sure rust has been sanded and wiped well.
Magnet on flywheel will sometimes loose their strength so will it hold a medium screwdriver?
Are you setting air gap between magneto and flywheel correctly? On older engines I set mine with a piece of fine grit sand paper or a piece of thin paper like an envelope open to be just one thickness of itself. I just let the magnet suck it up to flywheel tighten the magneto and rotate flywheel to remove paper.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Step by Step Carburetor Overhaul - 1952 Ford 8N - by Don Stewart. The carburetor kit for the TSX-241A/B/C carburetor is being supplied in only one flavor nowadays. It includes a replacement throttle shaft, new butterfly valve screws, fuel inlet filter, new float needle and seat, new float pin and
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
