|
Tractor Talk Discussion Board |
Honing cylinders
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Howard on January 31, 2001 at 04:24:29 from (199.218.162.51):
Hey Guys,
Thanks for the excellent ideas on pulling cylinder liners. Now that I can do it, I'm not sure I want to. Honing in place sounds like a good idea, but my knowledge of and tools necessary to hone is limited to a photo I saw in a 'How to Hotrod Small-Block Chevys' book 25 years ago. I'm willing to try. What will I need to do the job right? Someone has installed new rings, but didn't hone the cylinders, and the tractor oil-fouls plugs in minutes. I'm having new valve guides installed, too.
Thanks for ALL your feedback, please help again.
Howard
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
It Can't Be Done! - A Tractor Story - by Neil Campbell. I'll never forget the time back when I was a boy baling hay on our Farm in Big Rapid, Michigan. The most memorable event that took place was a trip up the steepest incline on the farm pulling an old New-Idea baler with a pony-motor for power and a haywagon. I had just talked my Dad into buying an old John Deere B with 6-speeds ahead and I was real proud of it, except it was a little smaller than the Case tractor that we normally
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
