If all your getting is "sand" then a cheap cartridge filter will fine. If you are not have'n problems with Iron, Manganese, or any taste and oders I would not be out the money for a "better" filter. When I had to use well water here at the house Lowes had some filter cartidges that said they got out iron and t and o problems. I put three in a row come'n it to the house and it took about a week for them to get saturated and stop working.
I have to ask, what does the sand look like? If you are the end of the line, they have not had a break, and there is no back flow from some where I wander what it is. Might be some reaction going on. If they are feeding a good bit of caustic and bleach and the feed points are close they may be "salting" out but that should be left in the plant. Most of the time reacations take place close to the source insted of at the end of the line. It could also be minneral build up that is breaking looks in the lines, do you notice any more or less of it after a wild pressure swing like when they flush lines?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
