Tractor Talk Discussion Board |
Re: Belt power
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Scott Green on January 30, 2001 at 14:53:38 from (209.130.138.230):
In Reply to: Belt power posted by Charlie on January 29, 2001 at 17:58:29:
We use to buzz wood with an oliver "70" on the belt. We would push some good size wood through that saw. No effort on the tractors end of it. If I remember right , the tractor was about 20 feet from the saw , when the belt was on it. When the wind was blowing just right , it would get the belt flopping side ways , and off the pullys. We had to stand a piece of pipe about half way. That was just enough that the wind would not work the belt off.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Tractor Parade: Story of a Case SC - by Bernie DeLon. On a early fall morning back in 1994, I opened the newspaper and happened to spy an article about a local antique tractor club having their annual show that weekend.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|