Re: Cylinder liners

Posted by Fred OH on January 30, 2001 at 10:27:14 from (208.32.116.37):

In Reply to: Cylinder liners posted by Howard on January 29, 2001 at 07:59:53:

The proper way to remove liners is with a hollow ram cylinder attached to a porta power with a plate machined at the bottom as described earlier. I use a piece of 3/4" all thread with mine and a piece of pipe machined square on the ends and as long as the liner. Then a plate on top of the pipe to set the ram on. The all thread runs through the whole contraption with a nut on each end. Then its just a matter of pumping the ram. These foreign manufacturers that make the ten ton porta power units don't know it but they could sell a lot more of their kits if the hollow cylinders were included in their kits for pulling with. You reckon they read these posts? We'll know if we see it for sale next spring. L8R----Fred OH

Follow Ups:

• Re: Re: Cylinder liners BFO 12:09:35 01/30/01 (0)
• Re: Re: Cylinder liners Shopguy 11:58:29 01/30/01 (0)

Post A Followup Name: E-Mail: Subject: Re: Re: Cylinder liners Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]