think of cornstalks like hay - they have to be dry when u make them and keep them dry to use as a straw. hey will be fluffy in the silo -
I have a 1915 experiment where they went out and put cornstalks in april in a silo - then added water - then packed them down then it turned into silage
I do a lot of experiments - haven't perfected it yet - piling the chopped stuff on the ground (even if covered) - i think to much moisture wicks up from the ground through the small particles
Also, chopping dry material through a forage chopper can dull the knives rather quickly.....
All in all, this is what i would do - this from a few years of experiments - wait until the stalks are dry (atleast a few days after combining) (or spring would be perfect if you can wait to disk /plow) - use an ordinary bar rake in the standing stalks - rake a couple swaths together then harvest.
If you round bale and net wrap - you will still need to tub grind or reduce particle size before using -
if u use the forage harvester then the battle is keeping the material u make dry - actually blowing into a mow might be better than a silo - this is awfully fluffy stuff
i am more looking to use the stalks as a feed source - so I am approaching this different
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Case VA Series - by Staff. V, VC, VI and VO). Althouh the Case VA looked much like the V, it shared no major components with its predecessor. Except for military units, the production of the Case VA was interrupted in July of 1942 due to World War II. It resumed again in 1944 and continued until 1953. It started up briefly later on in 1953 and continued on a very limited basis until 1956. The VA Series included the following models: VA: Fixed front wheel tread VAC:
... [Read Article]
Latest Ad:
Massey Ferguson model 65 diesel tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
