There are many ways to build. I like pole construction because one person can do it (slowly). Also, if you get the poles tight into the ground, they support the walls vertically -unlike a frame building that cannot support itself until a complete roof structure is in place. I just built a 40' x 60' barn by myself. Note though that I had a backhoe to use as a crane to sit trusses in. I could of done without if lower, but this has 12' ceilings.
With steel buildings, some are pole construction, some are arch, some are steel frame.
Pole buildings usually get anchored to the ground with pressure-treated poles sunk below the frost line. Code requires 5' deep here. In high wind areas they can get concrete anchors poured around the bottoms if you're not pouring a concrete slab later. In NY 6"X 6" poles are standard. In northern Michigan, 4" X 6". Roof goes real fast if you use trusses, purlins, and 36" wide steel. Steel also sheds snow nicely. Downside is it gets condensation on the underside unless you use a vapor barrier. I join pole barns to the ground with pressure-treated 1/2" CDX plywood skirting, buried two feet deep. 2' in the ground and 2' above. Then your siding - whatever your choice is. Some compaines like Morton run the steel siding to the ground and bury in gravel. Vertical wood siding looks nice but steel goes up much faster. If you want to use vinyl, it gets trickier since it goes horizontal and not veritcal. Concrete slab can be poured last right against the skirting and poles. If done this way, it's all the anchor you'll ever need. Other steel buildings are basically made from huge steel culvert pipe. They require a good concrete foundation to sit on. Obviously there are many others ways to construct barns, sheds, and buildings. Pole construction is my favorite because it does not require a crew of people. I've got a four story barn here that's all pole, and you'd never know it by looking from the outside.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Museum Coverage: The Stuttgart Agricultural Museum - by Cindy Ladage. While cold wind was blowing back in Illinois, in Arkansas, daffodils were in bloom, and the Magnolia trees were adorned with fragrant blossoms. Stuttgart, Arkansas was the site of this year's winter Minneapolis Moline Collector's show February 25-27, 1999. The show was held at the Oliver Museum created by Don Oliver, the pioneer of the four wheel drive tractor. Oliver along with Gale Stroh and Kenneth Bull using Minneapolis Moline tractors and parts created what has become known as
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
