Posted by ChrisB on November 18, 2009 at 15:20:45 from (97.95.187.61):
In Reply to: Best zero turn mower posted by fudpucker on November 18, 2009 at 10:11:31:
I have a Bob-Cat (not affiliated with the Skidsteer company) and it has been fine. Nice and well built and heavy with a welded deck. Motor on the other hand has not. B&S has crapped out twice within 400 hours. I should of upgraded to the Kawasaki.
Careful on sticking with the welded steel decks. While it is true that they are more commercial and definitely heavier duty, the advantages of a stamped steel deck are starting to come through. They have better suction, lift, vacuum or what ever you want to call it, of the grass before cutting. Granted the stamped steel is thinner but some commercial mowers are switching to stamped steel decks for the more refined cut they leave. If you are looking as a homeowner, there is nothing wrong with a good quality stamped steel deck. Even more so if you are looking for a manicured looking cut. I used one of my neighbors stamped steel decks on my lawn and was impressed. Sort of the reason that JD is working hard on making a better stamped steel deck as someone previously mentioned.
Also, weight is not everything. While heavy duty steel is nice the less pressure your mower puts on the lawn the better. That is why you see a lot of the pros using walk behinds.
I just have a heavy duty, welded steel deck commercial mower as a homeowner and learned some of the disadvantages of them.
BTW a trick I was taught about frame stiffness. If you mow a lot with the mower and see one of the front wheels come completely off the ground while traveling over bumps (easy to notice the way the front wheels work on a zero turn) , the mower is indeed very stiff.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Two-Brush Generators - by Chris Pratt. Whether for product liability or because the aftermarket parts and labor business is lucrative, this concept is disturbingly prevalent. Fortunately when you step into your shop and make that jump 50 years back in time to work with your old tractor, this concept goes out the window. Even so, when it comes to the charging system, people quickly revert to this idea and start replacing the major components one at a time until it works. The reason you don't find any decals in your replacement set wit
... [Read Article]
Latest Ad:
WANTED IH C200 gas engine — complete running motor Wanted complete used IH C200 gas engine in running condition for an International 574 gas tractor. My block has a hole in it and is dead, so a rebuild kit wont do it — need a whole running motor. The C200 also came in the 544 and 674 gas trac
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
