|
Tractor Talk Discussion Board |
Re: 14T Baler
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by oldnnew on June 05, 2007 at 09:09:18 from (170.3.8.253):
In Reply to: Re: 14T Baler posted by Bob on June 05, 2007 at 06:34:11:
I happened to have the operator's manual right in front of me. It states: "The bale measuring arm may be set for bale lengths of 12 to 50 inches. The length of the bale may be shortened by loosening the set screw and lowering the stop." (this stop is located on the aformentioned J hook.) If I had a scanner here, I would scan the page for you. Hope this helps.
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Talk of the Town: Diesel Vs. Gasoline - by Staff. Another neat discussion from the Tractor Talk Discussion Forum. The discussion started out with the following post: " I am in the market for an older tractor (to be read... cheap). I have been told a diesel holds up better than a gasoline engine as far a wear, tear, neglect and abuse. Since I am looking at older tractors that have probably been through it all, is it better to buy diesel? I do expect to have to do a good bit of work on
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
