Posted by J Heitkemper on November 10, 2009 at 18:43:47 from (98.108.1.236):
In Reply to: Re: Tub Grinders posted by WGWKy on November 10, 2009 at 17:00:37:
JUST tellin You about Our neck of the woods ,, You might have better LUCK OK<>...tub grinders will gut the chitt out of a pto clutch ,,, Don't Matter how TUFF that 4020 is ,, The PTO will not hold up to that ABUSE .. You should have 150 horses ,And a heavy PTO to carry it ....Check and maintain all oil levels in Tranny and PTO clutch area if SEPERATED , RELIGOUSLY, Get that PTO adjusted to factory SPECS before hooking up the PTO ,, and every 2 years or until you have had enuf and sell the tub grinder, after destroying the PTO .. be Prepared for a expensive trip to the shop to fix the clutches ...
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Converting from 6 Volt to 12 Volt - by Chris Pratt. It's a common problem for old machines especially when the weather starts to dip below 40 and the tractor isn't fired up as often. You are probably used to the 12 volt Diehard, charged with 200 amp alternator of your 3/4 ton that always is ready and always starts. It's this type of experience that brings about the many queries we get for 12-volt conversion kits. Since only a few kits are available (we sell kits for the
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
