Posted by steve n carol on November 06, 2009 at 21:45:50 from (71.110.65.26):
In Reply to: Concrete slabs posted by Alex.C on November 04, 2009 at 18:33:29:
The building is not supported by the 'slab'.
As mentioned, the footing around the perimeter (including the openings/doors), support the building and should all tied in with rebar. The size of the footing depends on the weight of the building. What are the walls made out of? Bricks, block, sheet metal? how high? 8', 14' etc. What kind of roof? (think about the weight). Also the footing holds down a structure...if it's attached to it, and it should be. As the wind goes over the top, it creates 'lift', like an airplane wing, not to mention tornados and such. Just ask Dorthy!
If you have columns in the 'field' of the floor area, a footing ('spread footing) is appropriate, as that column or post will carry some weight as well.
And, as mentioned, check with your county or city, they will give you a free design handout....sl
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Sunday Drives - by Cowboy. Summer was finally upon us here in Northern Maine. We have two types of industry up here, one being "Forestry" (Wood Products) and the other "Farming" (Potatoes). There is no shortage of farm tractors and equipment around here! I have been restoring old Farm Tractors for the past 6 years, and have found it easier and less expensive to hit all the auctions and purchase whole tractors for parts needed. My wife who works at a local school, and only has weekends and summers off, while on t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
