|
Tractor Talk Discussion Board |
Re: Need help with Case Terratrac I D
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by twopop on January 23, 2001 at 18:18:56 from (208.224.41.15):
In Reply to: Need help with Case Terratrac I D posted by Levi on January 22, 2001 at 16:32:27:
there should be a small plate on the side of the pump,held on with two screws.behind the plate you will see part of the distributer plate.this plate should turn when the engine is cranked.if it doesnt the drive shaft is broken,which usually happens if there is water in the fuel.if you havent taken the pump off,it probably doesnt need retiming.in order to time it you would need to know at what degree the pump is supposed to inject fuel.somewhere on the engine you should find a timing mark of some kind.either on the crank pulley or the flywheel.you would have to set the engine at the tdc mark or the proper degree,on the compression stroke.thru the plate on the pump you should see a stationary line,and there is a line on the distributer plate.these two lines have to line up.also,when you take the plate off,you loose prime.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Recollections of a John Deere GP - by Charlie Cook. I grew up on my dad's 280 acre general farm in Western Michigan. Dad's only tractor when I was very young was the old GP. My first recollection of this tractor was when dad allowed my brother and myself to ride on the tractor with him driving. One of us would sit on the left fender (away from the clutch) and other would sit on the gas tank and hold onto the crankcase breather pipe.
... [Read Article]
Latest Ad:
1952John Deere MT tractor
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|