Re: electronic ignition

Posted by John T on June 05, 2007 at 09:02:08 from (66.244.83.147):

In Reply to: electronic ignition posted by smdv806 on June 05, 2007 at 08:21:00:

Perhaps it was just BAD to begin with?? Other things may be that the current rating of the electronic switch was NOT compatible with the coil??? I believe some of the Pertronix Flame Thrower high energy coils require a higher current rated switch then their normal switch used for tamer or stock coils that draw less current.

Grounds and wiring and connections can contribute to problems, but if its already fried you better check with pertronix and hope your switch was matched up for whatever coil you used. If you used the old stock coil the off the shelf elec switch should have handled that fine.

I guess your switch matched your tractor voltage and ground??

John T

Replies:

• Re: electronic ignition oldnnew 09:05:12 06/05/07 (0)

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]