Posted by Leroy on November 04, 2009 at 06:25:03 from (209.143.52.155):
In Reply to: building a hayrack posted by jacksonduper on November 03, 2009 at 12:27:20:
You say a green chopper so I figure you must be meaning a flail chopper and as I have not heard of any being made for years the John Deere 15 & 16 being about the newest that I know of they all are a design that is 30-40 years old and with those older models they will not load a long wagon like the new forage harvesters will. We had a John Deere No.10 flail chopper and it had trouble filling the back of a 14' bed. We had some shorter leg type of cattle so height was an issue and we wanted the bed as low as possible and the wagon gear was a wood wheel gear with rubber put on and with the fifth wheel type of steering we had to use a low height sill to clear tires while turning and still not get it too high the cows could not reach in the bed to eat so we used 4 X 6 treated posts with just boughten 2 x 6 lumber for the floor nailed cross ways of the sills so as to not add any aditional height. We also only made it 6' wide so the cows could reach the middle to get the feed, we made a V hopper the length of the bed with about 2' open on the botton for the feed to drop down thru. Only used treated lumber where the cows could not get to it, rest standard lumber yard material and lasted for years and sold the bed when the dairy heard left along with the hay machinery. We had 3 16' and 1 18' wagon and the 18' was the last to load as was way to much walking to load. Before we got the feed bed built we tried loading on the 16' flat bed and it just did not work and the chopper would not get the feed to the back of the bed. Everybody is talking about way overdoing the beds, no way do you need anything that heavy.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
