Posted by Mathias NY on October 31, 2009 at 15:38:33 from (69.207.112.28):
In Reply to: Ford 3000 3 point. posted by jubileejim on October 31, 2009 at 13:44:40:
There is a lever on the right hand side, near the 3pt lever. It switches between draft control and position control. Try switching it, I can't remember which position does what.
My 3000 has a similar problem, even when it's in position mode. If I run the engine up over 1500 rpm, it will lift just fine, but not at an idle. The 3pt also has a tendency to hop up slightly when weight is added or removed. I've had it apart myself and at the repair shop, it's not an obvious problem. My latest idea is that some of the internal linkages are mismatched. But it works enough to get me through, so I haven't torn into it again.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Old Abe is Still Making Hay - by Jeremy Sweeten. Things have changed a bit since my last article. I am now almost finished graduate school at Purdue University. I am still in Agronomy, but specializing in hay and forages. My wife has survived two years of marriage to a part-time farmer. The equipment line up has changed a bit too. The DC has retired to
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
