Re: Re: Re: Sand blasting Tractor Sheet Metal??

Posted by MoosieDog on January 16, 2001 at 08:09:04 from (12.91.126.21):

In Reply to: Re: Re: Sand blasting Tractor Sheet Metal?? posted by Brian on January 15, 2001 at 06:56:10:

Found the best buy on a needle scaler from one of the tool supply houses on the internet. As far as distorting the sheet metal, I run mine at about 90 psi with the scaler set back to the least vibration strokes. Yes, I too use it to finish off welds and do heavy rust removal, but then I crank up the psi and reset the stroke. Also, for sheet metal, I use a set of needles that are a bit rounded from wear. No sharp edges. I scale, light sand with an air sander and prime. I'm no expert on finishes, but I'll be darned if I see any surface distortion on my finished old red tractors.

Follow Ups:

Post A Followup Name: E-Mail: Subject: Re: Re: Re: Re: Sand blasting Tractor Sheet Metal?? Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]