Posted by steamnjn23 on October 22, 2009 at 22:48:15 from (24.176.158.229):
In Reply to: Diesel glow plugs posted by Jim Plunkett on October 22, 2009 at 15:55:24:
b.jones said: (quoted from post at 18:55:24 10/22/09) Does anyone know where you could buy 12 volt glow plugs with a 7/8 inch by 14 tpi. I think that is about the standard 7/8 inch thread. I once found some that hooked up to diesel fuel. I am looking for ones that will heat the intake air. Thanks.
yes.
the plugs that you describe are the same ones in my ford 951.
after considerable research one rainy afternoon, i discovered that you need to ask for glow plugs for a 1980 volkswagen jetta. they will typically be about $12 each.
they use the same cross reference number as my tractor. i'm not sure at this point what the part number is, but when i find it, i'll post it back here.
are you sure yours are bad?
i was until i saw the inital asking price at a local parts dealer. then i went to the barn with my digital meter in hand and found out it was a bad switch, and not the plugs.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Two-Brush Generators - by Chris Pratt. Whether for product liability or because the aftermarket parts and labor business is lucrative, this concept is disturbingly prevalent. Fortunately when you step into your shop and make that jump 50 years back in time to work with your old tractor, this concept goes out the window. Even so, when it comes to the charging system, people quickly revert to this idea and start replacing the major components one at a time until it works. The reason you don't find any decals in your replacement set wit
... [Read Article]
Latest Ad:
WANTED IH C200 gas engine — complete running motor Wanted complete used IH C200 gas engine in running condition for an International 574 gas tractor. My block has a hole in it and is dead, so a rebuild kit wont do it — need a whole running motor. The C200 also came in the 544 and 674 gas trac
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
