Posted by kyplowboy on October 16, 2009 at 20:02:50 from (63.146.226.90):
In Reply to: baler opinions posted by Erik Ks Farmer on October 16, 2009 at 18:57:16:
Don't know about the newer ones but with the older balers in my price range I like the Vermeer. Some one else may know if this is still true or not but the newest one I have been around (Super H I think) parts were a whole lot cheaper. You can get bearings at any NAPA or industrial bearing joint for a fraction of the cost of any speacial red or green one.
Like others have said alot comes down to which dealer you have close you like.
My grandfather has a NH 664 that he bought new several years ago. He likes the baler it's self but he has said many times "bale command" is the worst idea NH has had since the 6000 commander tractor.
As for net wrap, I am a fan. If I ever get a newer baler it will have net. Only cost $1.50 a bale, is quicker, and saves a world of hay. I buy some hay every year and will pay or drive a few more miles for wrapped hay. Some folks don't, but I always take it off before I feed it. Some folks say it will get knotted up in a cow gut some say it won't. Many of the folks who don't like it fuss about how it get tangled up in mowers, cutlivators, and wrapped around tractor wheels and eats up seals. If you pull it off, wad it up, stuff it in a feed or seed sack, and burn it every year it never gets tangled in anything.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - 12-Volt Conversions for 4-Cylinder Ford 2000 & 4000 Tractors - by Tommy Duvall. After two summers of having to park my old 1964 model 4000 gas 4 cyl. on a hill just in case the 6 volt system, for whatever reason, would not crank her, I decided to try the 12 volt conversion. After some research of convert or not, I decided to go ahead, the main reason being that this tractor was a working tractor, not a show tractor (yet). I did keep everything I replaced for the day I do want to restore her to showroom condition.
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
